Repair Tips

How to fix a dripping faucet without calling a plumber

A dripping faucet in Decatur GA is usually a worn washer or cartridge you can replace yourself in under an hour. Here is the step-by-step fix.

P
Plumber DecaturNovember 2026 · 9 min read
How to fix a dripping faucet without calling a plumber

A dripping faucet is almost always caused by a worn rubber washer, a failed O-ring, or a corroded cartridge seat - and you can replace any of those yourself in under an hour with a screwdriver, an adjustable wrench, and a $3 to $15 replacement part. The fix is genuinely DIY-friendly. You do not need a plumber for a single slow drip at one fixture. What follows is the exact process we walk Decatur homeowners through on the phone, plus the point where a drip stops being a DIY job and starts being a symptom of something bigger.

Why your faucet is dripping in the first place

Fix dripping faucet Decatur GA work starts with understanding the mechanism. Water sits under pressure behind the handle at all times. A rubber or ceramic seal holds it back. When that seal wears, water escapes one drop at a time.

Decatur's water is moderately hard - roughly 3 to 7 grains per gallon depending on the side of town - and that mineral content slowly grinds down rubber washers. A washer that lasts ten years in soft water might last five or six here. Homes in older neighborhoods with original 1950s plumbing tend to see it sooner.

Three failure points cause 90% of drips:

  • Washer - flattens against the valve seat and stops sealing. Common on two-handle compression faucets.
  • Cartridge or ceramic disc - cracks or collects grit. Common on single-handle kitchen and bath faucets.
  • O-ring or seat - dries out and lets water slip past the stem. You will usually see a drip from the base of the spout, not the tip.

If the drip comes from under the handle rather than the spout, that is a stem O-ring. If it comes from the spout tip, it is the washer or cartridge. That one detail tells you which part to buy before you even shut off the water.

What you need before you start

Gather everything first. A mid-repair trip to the hardware store is how a 30-minute job becomes a three-hour one.

  • Adjustable wrench or a basin wrench for tight under-sink spaces
  • Phillips and flathead screwdrivers
  • Allen key set (most single-handle faucets hide a set screw under the handle cap)
  • Replacement washer, O-ring, or cartridge matched to your faucet brand and model
  • Plumber's silicone grease
  • White vinegar and a small brush for mineral buildup
  • A towel and a small bucket

Find the model number stamped on the faucet body or under the handle cap. Take a photo of it with your phone and bring it to the store - big-box employees match cartridges by model number, not by eye.

Shut off the water at the two supply valves under the sink. If those valves are seized or weeping, stop there and call us - a snapped shutoff valve turns a $12 repair into an afternoon of mopping. We handle that exact situation on emergency plumbing services Decatur calls regularly.

How do I fix a dripping faucet in Decatur GA?

Fix a dripping faucet in Decatur GA by shutting off the supply, disassembling the handle, replacing the worn washer or cartridge, and reassembling in reverse. Here is the full sequence.

  1. Shut off both supply valves under the sink and open the faucet to release pressure.
  2. Plug the drain with a rag so small screws cannot fall in.
  3. Remove the handle. Pry off the decorative cap, unscrew the retaining screw, and lift the handle straight up.
  4. Expose the valve. Remove the packing nut with your wrench, then pull the stem or cartridge straight out.
  5. Inspect the parts. Look for a flattened washer, a cracked cartridge, or white mineral crust. Soak metal parts in vinegar for 20 minutes if they are scaled.
  6. Replace the worn part. Match it exactly at the store. Coat the new washer or O-ring with a thin film of silicone grease.
  7. Reassemble and test. Tighten the packing nut snug - not gorilla-tight - then restore water and run the faucet for a full minute.

Total time for a compression faucet: 20 to 40 minutes. For a cartridge faucet: 30 to 60 minutes. If the drip continues after a fresh washer, the valve seat itself is pitted and needs resurfacing or replacement - that is the point where most homeowners hand it off.

Fixing a cartridge faucet vs. a compression faucet

The two designs need different parts and slightly different techniques. Getting this wrong is the number one reason a DIY faucet repair Decatur attempt fails on the first try.

Compression faucets (two handles, one for hot and one for cold)

These are the older style, still common in Decatur homes built before 1980. Each handle has its own stem with a rubber washer at the bottom. When you turn the handle, the washer presses down on a metal seat to stop flow. The washer is the part that fails. Replacement washers cost $1 to $4. Bring the old one to the store - they come in numbered sizes.

Cartridge and ceramic disc faucets (single handle)

Modern kitchen and bathroom faucets use a cartridge that slides in and out of the valve body. Cartridges cost $8 to $25 depending on brand. Moen, Delta, and Kohler cartridges are widely stocked in Decatur. Some manufacturers warranty cartridges for life - check the brand before you pay, because a free replacement is a five-minute phone call.

If your faucet is a specialty or imported fixture and you cannot find the cartridge locally, that is a legitimate reason to bring in help. Our faucet repair Decatur GA service carries common cartridges on the truck and can usually source odd ones within a day.

What does faucet drip repair cost in Decatur GA?

Faucet dripping cost to fix Decatur GA runs $3 to $25 if you do it yourself and $125 to $280 if you hire a licensed plumber in 2026. The spread depends almost entirely on the faucet type and whether the part is in stock.

  • DIY washer replacement: $3 to $8 in parts, 20 to 40 minutes of your time
  • DIY cartridge replacement: $8 to $25 in parts, 30 to 60 minutes
  • Professional repair, standard faucet: $125 to $200 including the part
  • Professional repair, specialty or imported faucet: $180 to $280
  • Full faucet replacement if the body is cracked: $200 to $450 installed

One slow drip at one drop per second wastes roughly 3,000 gallons a year. At Decatur's current water rates, that is $40 to $70 a year down the drain - which is why even a $200 professional repair pays for itself within a few years. If you are seeing unexplained increases on your water bill alongside the drip, we recommend leak detection Decatur GA to rule out a hidden line problem before you assume the faucet is the only culprit.

Common mistakes to avoid

Most failed DIY faucet repairs come down to one of these five errors. Avoid them and your fix will hold.

  • Overtightening the packing nut. This crushes the new washer and causes a fresh leak within a week. Snug plus a quarter turn is enough.
  • Reusing a worn O-ring. If you have the faucet apart, replace every rubber part you can see. They cost pennies.
  • Skipping the vinegar soak. Mineral scale on the valve seat will chew through a new washer in months. Clean the seat before you reassemble.
  • Buying a generic cartridge. Off-brand cartridges fit loosely and drip again within weeks. Match the manufacturer.
  • Forcing a seized shutoff valve. If the valve will not turn by hand, stop. Forcing it snaps the stem and floods the cabinet.

One more: do not ignore a drip that comes back after two or three repairs. That pattern usually means the valve seat is pitted or the line pressure is too high. Homes in plumbing services Oakhurst GA with older galvanized lines see this more often than newer construction, and it is worth a professional look.

When to call a professional

Call a plumber for a dripping faucet when the drip returns after a fresh washer, when water appears under the cabinet, when the shutoff valve will not close, or when the faucet body itself is cracked. Those four situations are beyond a DIY fix and can turn into water damage fast.

We also get called when a homeowner has tried the repair twice and is tired of the hardware store run. That is a fine reason to call. Our team diagnoses the faucet, replaces the correct part, and tests the fixture before we leave - usually in a single visit.

If you are dealing with multiple drips across the house, or a drip plus low pressure at every fixture, the issue is likely in the supply lines rather than the faucets. That is a different job, and it is one we handle as part of our plumbing services Decatur GA work every week.

Frequently Asked Questions

How do I fix a dripping faucet in Decatur GA?

Shut off both supply valves, remove the handle, pull the stem or cartridge, and replace the worn washer or O-ring. Reassemble, restore water, and run the faucet for a minute. Most repairs take 20 to 60 minutes and cost under $25 in parts.

Can I fix a dripping faucet myself in Decatur?

Yes, for a single slow drip at one fixture. Washer and cartridge replacements are genuinely DIY jobs. If the drip returns after one repair, or you see water under the cabinet, that is when a licensed plumber saves you time and money.

When should I call a plumber for a dripping faucet in Decatur GA?

Call when the drip continues after a fresh washer, when the shutoff valve will not close, when the faucet body is cracked, or when water pools under the sink. Those four signs point to a problem beyond the faucet itself.

How much does faucet repair cost in Decatur?

DIY parts run $3 to $25. A licensed plumber in 2026 charges $125 to $280 depending on faucet type, including the replacement part. Full faucet replacement, if needed, runs $200 to $450 installed.

Why does my faucet drip after I replaced the washer?

A pitted valve seat is the usual cause. The new washer cannot seal against a rough surface. Resurfacing the seat or replacing the faucet body solves it. High line pressure above 80 PSI can also cause repeat drips.

Get help with Plumber Decatur in Decatur

If your DIY repair did not hold, or you would rather skip the hardware store trip entirely, our team handles faucet repair across Decatur and the surrounding neighborhoods. We diagnose the fixture, replace the right part, and test it before we leave.

Call plumber Decatur at 513-299-2719 to schedule a visit.

Common questions

Good questions

(831) 293-1204 →

Shut off both supply valves, remove the handle, pull the stem or cartridge, and replace the worn washer or O-ring. Reassemble, restore water, and run the faucet for a minute. Most repairs take 20 to 60 minutes and cost under $25 in parts.

Yes, for a single slow drip at one fixture. Washer and cartridge replacements are genuinely DIY jobs. If the drip returns after one repair, or you see water under the cabinet, that is when a licensed plumber saves you time and money.

Call when the drip continues after a fresh washer, when the shutoff valve will not close, when the faucet body is cracked, or when water pools under the sink. Those four signs point to a problem beyond the faucet itself.

DIY parts run $3 to $25. A licensed plumber in 2026 charges $125 to $280 depending on faucet type, including the replacement part. Full faucet replacement, if needed, runs $200 to $450 installed.

A pitted valve seat is the usual cause. The new washer cannot seal against a rough surface. Resurfacing the seat or replacing the faucet body solves it. High line pressure above 80 PSI can also cause repeat drips.

Tap to call(831) 293-1204