Licensed installs, code-correct venting, same-day quotes

Tankless water heater installation Decatur GA for endless hot water

Tankless water heater installation Decatur GA replaces your tired tank with a wall-mounted unit that heats on demand, so the shower never runs cold. We size the unit to your household, run the gas or 240-volt line, and handle DeKalb County permitting. If you are comparing tankless water heater install Decatur options, we will quote the job the same day you call.

↗
Fast online booking

Request service today

Tell us what is happening. Our local team will confirm your visit shortly.

No spam. No obligation. Just practical help.
Thanks — we'll call shortly to confirm your visit.
Experienced Plumber Decatur professionals at work
Careful work. Honest options.
About this service

Tankless water heater installation Decatur GA, explained

Tankless water heater installation Decatur GA is the trade process of mounting, piping, wiring, venting, and commissioning an on-demand water heater so it delivers hot water within seconds of a fixture opening. There is no storage tank. A gas unit fires a burner only while water flows; an electric unit powers heating elements inside a sealed chamber. We hang the unit on a rated wall, run copper pipe or PEX tubing to the existing hot and cold stubs, install the correct Category III stainless vent or 240-volt circuit, then set outlet temperature and flow rate to match your fixtures.

Most Decatur homes we walk into still run a 40- or 50-gallon tank in a closet, basement, or attic. When that tank starts leaking or the household outgrows it, homeowners call us for tankless water heater services Decatur Georgia because they want the closet space back and hot water that does not quit. We also handle tankless water heater replacement Decatur jobs where a builder-grade unit has scaled up or failed. If you have been searching for tankless water heater installation near me Decatur GA, we cover every neighborhood inside the perimeter and most of DeKalb County.

  • ✓ Endless hot water
  • ✓ Lower standby loss
  • ✓ Reclaims closet space
  • ✓ Longer service life
What's included

What our tankless installation includes

Every install we do covers the full scope: the unit, the permit, the venting or circuit, the gas or electrical work, the haul-away, and the walkthrough. Add-ons like a recirculation pump or a water softener are quoted separately if you want them.

✓

Unit and materials

The tankless water heater itself, plus copper pipe or PEX tubing, pipe fittings, Teflon tape, pipe dope, and a new isolation valve kit. We use the same materials we would put in our own homes, and we do not substitute builder-grade parts to hit a price.

✓

Permit and inspection

We pull the DeKalb County plumbing permit and any required gas or electrical permit, then meet the inspector on site. You do not have to be home for the inspection. The signed-off permit stays with the house and matters when you sell.

✓

Venting or dedicated circuit

Gas units get Category III stainless venting routed to code with correct clearances. Electric units get a dedicated 240-volt circuit with the right breaker and wire gauge. We do both in-house, so there is no waiting on a second trade to show up.

✓

Old unit haul-away

We drain, disconnect, and remove the old tank at no extra charge. That includes getting it out of tight closets and up basement stairs. You are not left with a 150-pound cylinder sitting in the garage waiting on a bulk pickup.

✓

Temperature and flow setup

We set outlet temperature, usually 120 degrees Fahrenheit, and test every hot fixture in the house at once to confirm the unit holds temperature. If you have a tankless tub or a high-flow shower, we adjust the setpoint so you do not notice a drop.

✓

Walkthrough and descaling plan

Before we leave, we show you the filter, the isolation valves, and the shutoff. You get a simple annual descaling schedule written down. Georgia water leaves scale in the heat exchanger, and that one habit is what gets you to 18 years instead of 10.

How it works

What our installation process looks like

01

Sizing and quote

We ask how many bathrooms, how many people, and whether you run a tankless or standard tub. Then we check incoming water temperature, gas meter capacity, and available vent path. You get a written price the same day, usually within two hours of the walkthrough.

02

Permits and prep

We pull the DeKalb County plumbing permit and, when required, the gas or electrical permit. We protect floors, shut off the old unit, drain it, and disconnect the gas or 240-volt feed. Old tanks get hauled off at no extra charge, so you are not stuck with a 150-pound cylinder in the garage.

03

Mounting and rough-in

We anchor the unit to blocking or a rated bracket, then run copper pipe or PEX tubing to the hot and cold stubs. Gas units get a dedicated line sized to the BTU input; electric units get a dedicated circuit. Every joint gets soldered or crimped and pressure-tested before we close anything up.

04

Venting and wiring

Gas tankless units need Category III stainless venting, and we route it to code with proper clearances from windows and soffits. Electric units need the correct breaker and wire gauge. We torque gas connections, check for leaks with a manometer and soap solution, and label the shutoff.

05

Commission and walkthrough

We set outlet temperature, typically 120 degrees Fahrenheit, then run every hot fixture in the house at once to confirm flow and temperature hold. You get a walkthrough of the unit, the filter, and the descaling schedule. Typical install takes four to six hours; complex retrofits can run a full day.

Tools & methods

Tools and methods we use

Purpose-built equipment, used by trained technicians — so the job is done accurately the first time.

Pipe cutter and soldering torch

For clean copper pipe cuts and soldered joints on the hot and cold stubs. A square cut and a properly heated joint is what keeps a connection leak-free for decades.

PEX crimping tool

For PEX tubing runs where copper is impractical, like tight crawlspaces or long vent-adjacent runs. Crimp rings are checked with a gauge before the line is pressurized.

Manometer

To measure gas pressure at the meter and at the unit inlet. A tankless unit needs the correct inlet pressure to fire reliably, and we confirm it before and after the install.

Leak detection equipment

For tracing hidden leaks before we quote a water heater job. If the real problem is a slab leak or a pinhole in copper pipe, we want to find it before you spend money on a new unit.

Sewer camera

For inspecting the drain line when a water heater replacement stirs up sediment. Older Decatur homes with clay or cast iron lines can back up, and the camera tells us whether root intrusion is a factor.

Water heater element wrench

For electric tankless and tank service work. The right wrench prevents stripped element heads and lets us replace a failed element without pulling the whole unit.

RIDGID and Milwaukee power tools

For cutting, drilling, and anchoring on install day. We carry cordless RIDGID and Milwaukee tools so we are not running extension cords through your house or waiting on a charged battery.

Real results

Before and after.

Oakhurst attic tank to wall-hung Navien

Before

A 50-gallon tank in the attic of a 1920s bungalow, 13 years old, with a slow leak staining the ceiling below. The family of five ran out of hot water every morning and had already patched the ceiling twice.

After

We removed the attic tank, installed a Navien condensing unit on the garage wall, ran new stainless venting, and upsized the gas line. Hot water now holds at 120 degrees through three simultaneous showers, and the attic closet is dry storage.

Kirkwood electric tank to electric tankless

Before

A 12-year-old electric tank tripping the breaker and leaving rust-colored water at every tap. The homeowner had already replaced the lower element once and was facing a second repair on a tank past its service life.

After

We installed an electric tankless unit on a dedicated 240-volt circuit with a new breaker and correct wire gauge. The rust-colored water stopped immediately, the breaker stopped tripping, and the homeowner avoided a gas conversion that would have added roughly $1,200.

Decatur Heights rental property same-day swap

Before

A leaking 40-gallon tank in a rental property with a tenant moving in the following week. The owner was out of state and could not be on site for the install or the inspection.

After

We pulled the permit, installed a Rheem tankless unit in a single day, hauled off the old tank, and coordinated access directly with the tenant. The unit was inspected and running before move-in day, with no gap in hot water service.

Problems we solve

Problems a tankless install solves

Most calls start with one of these four complaints. Each one has a fix, and none of them require living with cold water.

Ask a pro →
01

Running out of hot water mid-shower

We size a tankless unit to your fixture count and household size, then set flow and temperature so the unit holds steady through simultaneous use. A family of four typically needs 8 to 10 gallons per minute, and we confirm that against your actual fixtures before quoting.

↗
02

Old tank leaking onto the floor

We shut down the unit, stop the water, and confirm whether the tank is repairable. In most cases a tank past 10 years is not worth repairing. We quote a tankless replacement and can often install within the same week, with the old unit hauled off.

↗
03

No space left in the utility closet

A wall-hung tankless unit frees the floor. We mount it on a rated wall or bracket, route the venting or circuit, and reclaim the closet. Many customers use the space for a pantry, a coat rack, or a stacked washer and dryer.

↗
04

High gas bill from standby heat loss

A tankless unit heats only when a tap opens, which drops standby loss to near zero. Decatur homeowners typically see a modest but consistent reduction in the gas line item. We can show you the efficiency rating on the unit we recommend so you know what you are buying.

↗
Transparent pricing

What tankless installation costs in Decatur

$2,800 - $5,500 depending on unit, venting, and gas or electrical upgrades

Typical 2026 pricing for a residential tankless install in Decatur runs $2,800 to $5,500, depending on the unit, the venting path, and whether your gas or electrical service needs upgrading. A like-for-like electric swap in a garage sits near the low end. A gas conversion with a new meter line, stainless vent run, and dedicated circuit sits at the top. We quote the exact number after a walkthrough so you are not comparing a real price against a phone estimate.

A tankless unit runs 18 to 20 years versus 8 to 12 for a tank, and it cuts standby heat loss to near zero. Spread over its service life, the installed cost is often lower per year than replacing two tanks, and you get continuous hot water the whole time.

01Unit type and size

A small electric tankless unit costs less than a high-capacity condensing gas unit. Sizing to your household matters more than brand, but a 199,000 BTU condensing unit with a stainless heat exchanger will always cost more than a basic electric model.

03Venting path

Category III stainless venting has to terminate with correct clearances from windows, doors, and soffits. A short vertical run through a roof is cheaper than a long horizontal run through a finished ceiling. Tight attic and closet paths add labor.

04Electrical work

Electric tankless units need a dedicated 240-volt circuit with the right breaker and wire gauge. If your panel is full or the run is long, that adds cost. We check panel capacity during the walkthrough so there are no surprises.

Proof you can check

Licensed, permitted, and warrantied

✓
Georgia Master Plumber LicenseGeorgia State Plumbing Board
✓
Journeyman Plumber LicenseGeorgia State Plumbing Board
✓
Backflow Prevention CertificationGeorgia State Plumbing Board
✓
OSHA Safety CertificationOccupational Safety and Health Administration
Customer reviews

What Decatur customers say

★★★★★
“Our 50-gallon tank was 13 years old and we were running out of hot water with two teenagers in the house. The crew quoted a Navien unit on a Tuesday and had it installed by Thursday. They ran new stainless venting through the attic and pulled the permit themselves. Six months in, no cold showers, and the gas bill dropped about $18 a month.”
MT

Marcus T.Homeowner, Oakhurst

✓ Verified
★★★★★
“Our old tank started leaking on a Sunday and we called Monday morning. They came out, confirmed the tank was done, and walked us through tankless versus another tank. We went tankless and had hot water by Wednesday afternoon. They showed us how to flush the unit every year and left the isolation valves installed. Straight answers, no upselling.”
DR

Dana R.Homeowner, Kirkwood

✓ Verified
Good questions

Tankless water heater questions Decatur homeowners ask

(831) 293-1204 →

Most residential installs in Decatur run $2,800 to $5,500 in 2026, including the unit, permit, venting, and labor. A straightforward electric swap in a garage can land near the low end. A gas conversion that needs a new meter line, stainless vent run, and electrical work sits at the top. We quote the exact number after a walkthrough, not over the phone.

Yes, if your household runs out of hot water or you want the closet space back. A correctly sized unit delivers continuous hot water and cuts standby heat loss. Payback on efficiency alone runs five to eight years. If you only use one shower at a time and your tank works fine, the math is weaker, and we will tell you that.

A like-for-like replacement takes four to six hours. A first-time conversion from tank to tankless usually runs six to eight hours, and older Decatur homes with tight vent paths or undersized gas lines can take a full day. We schedule the permit and inspection separately so the install day is not held up waiting on paperwork.

They cut standby heat loss, which is the energy a tank burns keeping 40 to 50 gallons hot around the clock. Decatur homeowners typically see a modest drop in the gas line item, more in winter than summer. The bigger savings show up over the unit's life: 18 to local experience versus 8 to 12 for a tank.

Ready when you are

Get your tankless water heater installation Decatur GA quote

Call us and we will size the unit, check your gas or electrical capacity, and give you a written price the same day. Licensed, insured, and permitted through DeKalb County. One call gets you hot water that does not run out.

Get a quote (831) 293-1204 →
Request an appointment

Contact Our Decatur Plumbing Team

Call us anytime, day or night. Our dispatch line is open 24/7 for emergencies, and our office is staffed Monday through Friday from 8 a.m. to 6 p.m. for scheduling and questions. We serve all of Decatur, Georgia and the surrounding DeKalb County area. If you have a leak, a clog, or no hot water, call now and we will get a plumber headed your way.

Call anytime(831) 293-1204Email the office[email protected]
Office hoursOpen 24 hours · 7 days a week
Request received — our team will be in touch shortly.
Tap to call(831) 293-1204